Easy Stride Walking Aid
Setup & Removal Guide
Choose the guide you need, then follow each step slowly. Ask for help if anything feels uncomfortable or unclear.
Before you start
Make sure you have enough space around you. Sit down or ask someone to support you if needed.
- 2 short guides
- Setup: 3 mins
- Removal: 2 mins
- Mobile friendly
Video could not load. Please refresh or contact support.
How to Put On Your Easy Stride
Fit the waist belt, adjust the leg braces, power the device on and check the walking mode.
Steps covered
- 1Prepare the device
- 2Adjust the hip width
- 3Secure the waist belt
- 4Fit the leg braces
- 5Power on and check the lights
- 6Select the walking mode
- 7Power off safely
Read written instructions
- Open the box and take out the walking aid.
- Hold it at the back and let the legs drop down.
- Open the side locks to set the hip width.
- Fasten the waist belt so it feels secure but comfortable.
- Sit each leg brace just above your knee.
- Leave about two fingers of space between your knee and the brace.
- Clip and tighten both leg braces.
- Hold the power button for four seconds.
- Check the lights before you start walking.
- Adjust the walking mode if you need to.
- Turn the device off when you have finished.
Video could not load. Please refresh or contact support.
How to Take Off Your Easy Stride
Switch the device off, remove the leg clips, undo the waist clip and pack the device back into the box.
Steps covered
- 1Turn the device off
- 2Remove the leg clips
- 3Undo the waist clip
- 4Close the hip width
- 5Place the device back in the box
- 6Lock the box
Read written instructions
- Hold the bottom button for four seconds.
- Press it four times until the lights turn off.
- Take the leg clips off first.
- Squeeze the clip on the inside of each leg to release it.
- Undo the clip in the centre of the waist belt.
- Push the hips together before packing.
- Place the left side into the box first.
- Lay the right side on top.
- Fit the device into the box and lock it.
Need help?
Stop if anything feels uncomfortable or unclear. Ask someone to support you before continuing.
QR instruction page by Automika